Hampton Bay Littleton Fans Instructions

Confirm that all the items you need are in the box: four ceiling fan blades, one mounting plate, one fan motor assembly, one motor housing, four blade brackets, one glass shade, one pull chain with fob, 19 screws, two lock washers, two metal washers, three plastic wire connecting nuts and 13 fiber washers.

Turn the power off to the electrical outlet box that the fan will be attached to.

Attach the mounting plate to the outlet box with a pair of screws and washers, using a slotted screwdriver while standing on a stepladder. Verify that the mounting plate is level and secured to the ceiling. Adjust the level with additional washers if necessary.

Lift the fan's motor assembly to insert the motor housing plate's "T" section into the mounting plate slot.

Attach the safety cable to the ceiling joist with a screw and a washer using an adjustable wrench.

Connect the black wire, which is the fan supply wire, and the blue wire, which is the light supply wire, to the black household power supply wire. Trim using wire cutters if necessary.

Attach the white wire from the fan (neutral wire) to the white household neutral wire.

Connect the fan's green wires, which are ground wires found on the mounting plate and motor, to the household green ground wire.

Move the motor assembly into position under the mounting bracket and attach it with screws.

Lift the housing onto the mounting plate by aligning the screw holes, then attaching with screws.

Attach a fan blade to a blade arm with a screw going into the blade arm, using a Phillips screwdriver. Do not tighten yet. Attach two additional screws in the same manner. Repeat for the remaining fan blades and blade arms.

Tighten each screw securely, beginning with the center screw and confirming that the blade is straight. Repeat for the remaining two outer screws, then for the other three fan blade and blade arms.

Insert the blade arm tabs into the slots on the bottom of the motor housing. Tighten with screws and washers to attach each blade arm to the motor.

Insert a light bulb (60 watts recommended).

Place the glass shade over the light bulb onto the light fixture by slightly unscrewing the thumbscrews that hold the shade in place. Secure the glass shade and tighten the thumbscrews until the shade is secure.

Reconnect the power to the electrical outlet box and turn on the fan to confirm that it is functional.