Things You'll Need
A plastic plate
J-B Weld
Rag
Toothpick
Putty knife
Rubber gloves
New tile can freshen any room, but adding an accent or design to that tile can really make a room pop. Stainless steel can give your room a classic look, and attaching the stainless steel pieces is easy with J-B Weld.
Step 1
Squirt dime-size piles of epoxy from both the black and red tubes of J-B Weld onto the plastic plate..
Video of the Day
Step 2
Stir the piles together with the tip of the toothpick.
Step 3
Scrub the tile surface with a rag to remove any dirt or debris. The tile should be clean and dry so the stainless steel will adhere to the tile.
Step 4
Use the putty knife to apply a thin (1/16 to 1/8-inch thick) coat of the epoxy mix to the back of the stainless steel. Leave a 1/4 inch of unglued area around the edges to prevent the epoxy from squeezing out when it's pressed against the tile.
Step 5
Firmly press the stainless steel piece against the tile. Wipe any drips with a damp rag. Allow it to dry for 15 hours.
Warning
Wear rubber gloves.
Video of the Day